MyMiniFactory
Computer
CableManager
by muzz64
0
Downloads
1.9k
Likes
0
Makes
If your device / Ethernet / power cables all too often ends up in a tangled mess then do yourself a favour and print a CableManager! This simple device prints in around 15 minutes (on a MakerBot), uses very little filament, and quickly clips into place on your devices power cable. Refer to the images for the recommended sequence. Once installed in this order you can unclip the length of cable required from each end to manage the length of cable as required... and secure it in a tidy coil when a
Melde dich an um zu kommentieren
Mit Google anmelden