myminifactory
3D Print of Avenger Strike Fighter - Yet to be put on base
Download Modelby Unbekannt
0
Downloads
0
Likes
0
Makes
0
Kommentare
Printed on Ender 3v2 and Ender 3 Pro. Took about 4 days of straight printing.
For best results I recommend splitting the main fuselage in half and printing each vertically. Print the tail vertically as well.
For the wings split them down the middle and print each section vertically, this gives the best results, similar for the tail wings and wing tips.
Missiles can just be printed vertically.
Careful handling the fuselage as it is easy to break off the heavy stubber, I had to superglue it back
For best results I recommend splitting the main fuselage in half and printing each vertically. Print the tail vertically as well.
For the wings split them down the middle and print each section vertically, this gives the best results, similar for the tail wings and wing tips.
Missiles can just be printed vertically.
Careful handling the fuselage as it is easy to break off the heavy stubber, I had to superglue it back