myminifactory
3D Print of Horse, tricolour silk (red/gold/black)
Download Modelby Unbekannt
0
Downloads
1
Likes
0
Makes
0
Kommentare
Yet another great creation from Matt.
First model (the one facing to the left) was printed at 65% with no difficulty.
The second model (the one facing to the right) was pushed to the extreme by reducing to 45% resulting in tighter tolerances but with careful manipulation the joints freed up and were comfortably mobile.
The tail was fragile however (especially with silk PLA) so I’d recommend not going smaller than 65%.
The tiny joint hinges would make this unsuitable for children who tend to
First model (the one facing to the left) was printed at 65% with no difficulty.
The second model (the one facing to the right) was pushed to the extreme by reducing to 45% resulting in tighter tolerances but with careful manipulation the joints freed up and were comfortably mobile.
The tail was fragile however (especially with silk PLA) so I’d recommend not going smaller than 65%.
The tiny joint hinges would make this unsuitable for children who tend to