E3D V6 bolt on mount for Solidoodle 4

The solidoodle 4 has a different mounting setup to the solidoodle 2 and 3. This is based off zlagger design that can be found on http://www.solidoodles.com/models/view/470

I cut off a few extra bits to make space for the side fan and that.

Ideally print in abs at 100% infill. The original bolts that held the SD4 extruder mount will be about 5mm too short so you'll need longer ones m3 x 30mm i think is what you need.

You'll also need to cut the spring down a little bit, one or two loops