E3Dv6 Shroud mounted fan ducts - 40mm heatsink and 30mm print fans

Uses original 30mm clip on fan duct as mounting system for easy removal.
Suits E3Dv6 hotend on OrdBot Hadron w/ BulldogXL(perpendicular to xcarriage + no mounting plate) but may suit others

Fans should click on - screw holes just in case and may need drilling

Position shroud with offset at top or ducts will be too close to heater block. Unit can still be adjusted up or down on the heat sink but add some aluminium foil tape to area above heat block if needs to be lower for your setup.