Thingiverse
Filament Guide for Wade's Extruder
by Dranoweb
3
Downloads
4
Likes
0
Makes
THIS IS A FAILED EXPERIMENT!
This was one of my earliest designs, and was designed to solve a problem that arose from incorrect construction of Wade's extruder.
I'm only leaving this here for historical purposes.
I've printed a few versions of this, but this one is NOT TESTED.
however the design is based on measurements from previous prints.
YOU WILL NEED:
2mm drill bit
Pederstool drill OR:
Some way to keep your drill perpendicular.
countersink tool OR:
large drill
This was one of my earliest designs, and was designed to solve a problem that arose from incorrect construction of Wade's extruder.
I'm only leaving this here for historical purposes.
I've printed a few versions of this, but this one is NOT TESTED.
however the design is based on measurements from previous prints.
YOU WILL NEED:
2mm drill bit
Pederstool drill OR:
Some way to keep your drill perpendicular.
countersink tool OR:
large drill
Sign in to leave a comment
Sign in