Thingiverse
Fan Duct For Use PLA Printing with an UP! Plus Or Afinia Printer
by mb20music
17
Downloads
10
Likes
0
Makes
Modified fan duct in Tinkercad to fit snug on the extruder and to mount a 50 mm fan.
I have the fan plugged into the 20 volt power jack on the back of the printer, I wired in a voltage step-down voltage module (ebay $4 US) that is adjustable and am running it @ approximately 14 volts.
I am finding that I get the best results when printing in "normal" mode and at .25 layer height settings.
I have the fan plugged into the 20 volt power jack on the back of the printer, I wired in a voltage step-down voltage module (ebay $4 US) that is adjustable and am running it @ approximately 14 volts.
I am finding that I get the best results when printing in "normal" mode and at .25 layer height settings.
Sign in to leave a comment
Sign in