Thingiverse
PanelDue 5i case with usable SD card access
by warpster
23
Downloads
5
Likes
0
Makes
PanelDue 5i case with usable SD card access.
Uses 7 M3 4mm x 3mm inserts and M3 bolts (4-18mm and 2 6mm) or longer M3 bolts (4- 22mm and 2 8mm) and nuts.
Many people say a 30cm cable is the longest you can use reliably with the SD readers but I made a 40cm cable and wrapped it in duct tape (the metal stuff they use to seal furnace ducts) and it has worked fine for years on several displays....
Supports are needed for the SD card slot opening but nowhere else/ I printed it with PLA since i
Uses 7 M3 4mm x 3mm inserts and M3 bolts (4-18mm and 2 6mm) or longer M3 bolts (4- 22mm and 2 8mm) and nuts.
Many people say a 30cm cable is the longest you can use reliably with the SD readers but I made a 40cm cable and wrapped it in duct tape (the metal stuff they use to seal furnace ducts) and it has worked fine for years on several displays....
Supports are needed for the SD card slot opening but nowhere else/ I printed it with PLA since i
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in