Thingiverse
Wall Mount for Component Drawers.
by Jeffeb3
12
Downloads
9
Likes
0
Makes
I knocked my little collection of component boxes over once. That was a pain. Besides, I want them off of my desk.
These are new boxes, with a thickened rear wall, and a slot cut in them. The slot allows for a small woodscrew to hold these mounts to a wall, and the interlocking fingers will let you hang your components to this mount.
These are the models available:
1x1x1_mount.stl: This has enough room for a 1x1x1_box in front, and it will be flush with the 1x1x2_box.
1x1x2_mount.stl:
These are new boxes, with a thickened rear wall, and a slot cut in them. The slot allows for a small woodscrew to hold these mounts to a wall, and the interlocking fingers will let you hang your components to this mount.
These are the models available:
1x1x1_mount.stl: This has enough room for a 1x1x1_box in front, and it will be flush with the 1x1x2_box.
1x1x2_mount.stl:
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in