Thingiverse
3FPD-MB Rep 2X-Active Cooling Duct-Rev3
by 3FPD
156
Downloads
118
Likes
3
Makes
This is the latest iteration of the Cooling Duct for the Makerbot Replicator 2X. (05May14)
It still prints with NO SUPPORTS!
NO MORE SCREWS...IT JUST SNAPS ON AND OFF!!!!! ;)
-Extruders(REV 5) in pictures are for modified custom PTFE lined feed tubes to custom finned heat sinks above custom hot-end using all original Makerbot heaters, and thermistors(Direct Replacement!). Specially made, and tested for FilaFLex, and Nijaflex filament as well as ABS, PLA, TEFLON, and others.
**** 30jun
It still prints with NO SUPPORTS!
NO MORE SCREWS...IT JUST SNAPS ON AND OFF!!!!! ;)
-Extruders(REV 5) in pictures are for modified custom PTFE lined feed tubes to custom finned heat sinks above custom hot-end using all original Makerbot heaters, and thermistors(Direct Replacement!). Specially made, and tested for FilaFLex, and Nijaflex filament as well as ABS, PLA, TEFLON, and others.
**** 30jun
Sign in to leave a comment
Sign in