Thingiverse
iFlight IX5 VTX Antenna holder 45 Degrees
by flabombarda
5
Downloads
3
Likes
0
Makes
This is a VTX Antenna holder for iFlight IX5 printed with TPU (100%infill suggested).
Doesn't require support/raft or any other special setting.
If you want to have it with more flexibility reduce the infill from 100% to 70% or 80%
The usage of this prevents a common situation of Antenna screwed directly to the frame on the top plate hole, this would ground the entire frame causing additional noise and with a major risk of a shortcut if any wire with (+) disconnects and touch the frame.
Doesn't require support/raft or any other special setting.
If you want to have it with more flexibility reduce the infill from 100% to 70% or 80%
The usage of this prevents a common situation of Antenna screwed directly to the frame on the top plate hole, this would ground the entire frame causing additional noise and with a major risk of a shortcut if any wire with (+) disconnects and touch the frame.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in