Thingiverse
E3D V6 mount for Creality CR-10 and 5015 fan
by im_a_bus_yo
19
Downloads
9
Likes
0
Makes
Added a 5015 fan mount and air duct. Duct is simply slid over and hot glued to the fan opening.
Also mirrored cable duct and added zip tie post on opposite side.
Cura prints fine, Simplify3d users click Mesh -> Separate Connected Surfaces before slicing.
Also mirrored cable duct and added zip tie post on opposite side.
Cura prints fine, Simplify3d users click Mesh -> Separate Connected Surfaces before slicing.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in