Thingiverse
CR-10 X Axis Level Guide
by CoffeeOutlaw
128
Downloads
59
Likes
1
Makes
Update: added version for ppl who still have the zstop switch installed
Over time the X axis on my cr-10 gets out of alignment so i designed this guide to make it simple to check and realign. screw them into your extrusion with 2 m4 screws and T-nuts. i leave them on all the time, just slid forward in t he slots so the hot end shroud does not hit them. when i suspect the bed is unlevel i raise the z. move the nozzle to the center. slightly loosen the screws and slide the guide back till it
Over time the X axis on my cr-10 gets out of alignment so i designed this guide to make it simple to check and realign. screw them into your extrusion with 2 m4 screws and T-nuts. i leave them on all the time, just slid forward in t he slots so the hot end shroud does not hit them. when i suspect the bed is unlevel i raise the z. move the nozzle to the center. slightly loosen the screws and slide the guide back till it
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in