YAFQ (Yet Another Fablab Quadcopter)

This is a frame for a quadcopter built using FabLab techniques.

Legs are laser cut 10mm MDF
Body is kind of a sandwich of two 5mm plywood with a 3D printed part in between to raise total inside height of the box to 15mm.

This piece is a wall 5mm thick with supports for the legs where the M3 screws are. It also has gaps to pass the ESC power and signal cables. ESCs are kept outside for cooling.

I don't have the electronics yet, but this is v0.1 for this parts:
NTM 2830S 900Kv with 1