Thingiverse
corner cable cover for 2020 so sides will fit on
by lokijester
50
Downloads
29
Likes
0
Makes
this is a cover for cables on a 2020 frame printer. just simply push the wires into the case and then push the case on the frame and it will clip into place.
it is made to run the cables from top to bottom without being seen although i have uploaded various sizes so can be used as just clips if you need.
just simply print out the parts until you get to the required size, push them in and slide them together.
it was designed to run cables down from the top of the printer to the bottom but all
it is made to run the cables from top to bottom without being seen although i have uploaded various sizes so can be used as just clips if you need.
just simply print out the parts until you get to the required size, push them in and slide them together.
it was designed to run cables down from the top of the printer to the bottom but all
Sign in to leave a comment
Sign in