Thingiverse
Teabag Dispenser with aluminium part
by Billyben
14
Downloads
15
Likes
0
Makes
Teabag dispenser with aluminium flat part. There is a front slot to show a single teabag.
It could be anchored with 2 screws, I've just use one.
Aluminiun flat : 30x2 mm x 104mm high
no support needed, You could stick with glue both part, but it's not loose on my printer.
It could be anchored with 2 screws, I've just use one.
Aluminiun flat : 30x2 mm x 104mm high
no support needed, You could stick with glue both part, but it's not loose on my printer.
Sign in to leave a comment
Sign in