Thingiverse
Trim Ring & Cap for P6*6 Pinhole Camera
by schlem
49
Downloads
39
Likes
0
Makes
This is a bit of embellishment for the P6*6 3D printed pinhole camera.
http://www.thingiverse.com/thing:157844
I dislike the flat, unfinished aspect of the front face of the extension on the P6*6, so I made a face plate for the "Shutter Clamp". Designed to NOT vignette the image projected onto the film, this needs to be securely glued in place, as popping the cap off exerts a small leverage on the trim ring. At this writing, I have used Super Glue to good effect.
For proper fit, the out
http://www.thingiverse.com/thing:157844
I dislike the flat, unfinished aspect of the front face of the extension on the P6*6, so I made a face plate for the "Shutter Clamp". Designed to NOT vignette the image projected onto the film, this needs to be securely glued in place, as popping the cap off exerts a small leverage on the trim ring. At this writing, I have used Super Glue to good effect.
For proper fit, the out
Sign in to leave a comment
Sign in