Thingiverse
E3D on Vertex K8400 (Rev 2)
by Bo_Ris
137
Downloads
100
Likes
6
Makes
This is the second revision of my E3D dual print-head mount for Vertex K8400 published here. The old design had the following issues:
- the lower ends of left and right holders were too close to the heat-blocks and could melt
- as the result of printing process imperfections there were several gaps in between things causing ducts to leak air
- air duct openings were not aligned with the nozzles
- there was insufficient airflow/cooling towards bearings located under the print-head
- the wir
- the lower ends of left and right holders were too close to the heat-blocks and could melt
- as the result of printing process imperfections there were several gaps in between things causing ducts to leak air
- air duct openings were not aligned with the nozzles
- there was insufficient airflow/cooling towards bearings located under the print-head
- the wir
Sign in to leave a comment
Sign in