Thingiverse
Azteeg X5 Mini V3 40mm extrusion mount.
by thehebs
17
Downloads
12
Likes
0
Makes
This is a mount for an azteeg x5 mini for openbuilds 40mm vslot extrusion (2040 or 4040).
Use m5x10mm screws to attach to extrusion. Use m3 x 12mm to attach board to mount. (In the photos, I used arduino washers and m3 x 16mm)
9/3/2016 - rev 1.5 - I adjusted fitment of the ports. I also shrank it down to 32mm total height. To achieve this, I could only allow for 2 mounting screw holes. I also added nut traps at the bottom, with a .25 mm support layer.
9/4/2016 - rev 1.7 - I added the
Use m5x10mm screws to attach to extrusion. Use m3 x 12mm to attach board to mount. (In the photos, I used arduino washers and m3 x 16mm)
9/3/2016 - rev 1.5 - I adjusted fitment of the ports. I also shrank it down to 32mm total height. To achieve this, I could only allow for 2 mounting screw holes. I also added nut traps at the bottom, with a .25 mm support layer.
9/4/2016 - rev 1.7 - I added the
Sign in to leave a comment
Sign in