Thingiverse
Mendel y-bar-clamp_10off remake in OpenSCAD w nut traps
by josefprusa
6
Downloads
9
Likes
2
Makes
Mendel y-bar-clamp_10off remake in scad
You can set if you want nut traps on bottom of the object, which also make it higher for added strenght.
Mendel part remake in OpenSCAD. Skeinforges faster and even prints better on some machines because of lower resolution holes!
-------------------
Remember that if you are using them, you only need 5 parts printed with nut traps. The other clamps will need to be of the plain type so that a washer and bolt rest properly on them.
---------------
You can set if you want nut traps on bottom of the object, which also make it higher for added strenght.
Mendel part remake in OpenSCAD. Skeinforges faster and even prints better on some machines because of lower resolution holes!
-------------------
Remember that if you are using them, you only need 5 parts printed with nut traps. The other clamps will need to be of the plain type so that a washer and bolt rest properly on them.
---------------
Sign in to leave a comment
Sign in