Thingiverse
bottle drying stand 3 leg
by staypatrick
12
Downloads
10
Likes
0
Makes
I love the original design but I felt I was wasting too much plastic on this. I designed a 3 leg version to save from printing 1 arm on the base. I will be printing this soon but I am sure it will be fine. i made sure the tolerances of .6 is the same across the board. I cut out one of the holes with tinkercad then filled in another so it held 0 legs. Then added that hole into the blank spots. Turned out quite nice. Legs are at 29 mm and inside is 29.6800 at the widest point.
Sign in to leave a comment
Sign in