Thingiverse
Heatbed strain relief for Duplicator i3
by Pawpawpaw85
242
Downloads
118
Likes
2
Makes
Wanhao Duplicator i3 v1.0 - Use Heatbed_Strain_Relief_1-6.STL
Wanhao Duplicator i3 v2.0 & v2.1 - Use Heatbed_Strain_Relief_V2_1-2.STL
The movement of the wires soldered to the heatbed was quite large and over time they might degrade and break off.
This strain relief should reduce the movement a lot at the solder joints, prolonging the life of the wires to the headbed.
Print in PET-G or ABS;
DO NOT USE PLA, IT WILL NOT HANDLE THE TEMPERATURE!
Depending on your printer settings, you
Wanhao Duplicator i3 v2.0 & v2.1 - Use Heatbed_Strain_Relief_V2_1-2.STL
The movement of the wires soldered to the heatbed was quite large and over time they might degrade and break off.
This strain relief should reduce the movement a lot at the solder joints, prolonging the life of the wires to the headbed.
Print in PET-G or ABS;
DO NOT USE PLA, IT WILL NOT HANDLE THE TEMPERATURE!
Depending on your printer settings, you
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in